![]() Select the LAN IP type of the access point or leave the default setting Smart IP for most cases, and then click Next. I don't know why I lost so much performance with this repeater thing. Either customize your Wireless Network Name and Wireless Password or keep the default ones, and then click Next. The LAN ports on the router cannot accept a DHCP address from your other router. Disable UPnP Disable DHCP Change the LAN IP address to an available address on your network. The DIR-615 has the latest firmware installed already. I've used the link below to setup my new D-Link DIR-868L router to be used as a Wireless AP. If I bring a LAN cable from the ISP router to the DIR-615, configure it as an AP, not a repeater, and set it as a different WiFi network, should I get a better performance? ![]() Does the repeater lose performance due the fact that it is repeating the WiFi signal? So the ISP router with its default WiFi is better than the repeater WiFi. When connected through the WiFi repeater, I get a speed test of 10Mbps and sometimes 4Mbps! If I am connected through the WiFi of the ISP router (that is a Humax HG100R), the speed of the connection is at full capacity, about 30 to 31 Mbps. I set it up with the same SSID and password as the ISP router so my wireless equipment can connect to it without the need to select a different SSID.īut I noticed that when I am connected to the repeater the internet speed is degraded a lot. ![]() The repeater function started to work okay. The physical setup for a wireless access point is pretty simple: You take it out of the box, put it on a shelf or on top of a bookcase near a network jack and a power outlet, plug in the power cable, and plug in the network cable. I have it set up accordingly to the manual. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |